DSLRKIT Active PoE Splitter Power Over Ethernet 48V to 5V 2.4A Micro USB Plug for Raspberry Pi B B+ 2 3

Product Information

The onboard PoE module supports 36V to 57V DC input and provides up to 1.8A (9W) output. While the module claims 1.8A, we've pushed it to 1.5A before the module hit 75C and the output began to sag below 4.5V. The PoE to USB Power Supply has 1.5KV isolation, thermal cut off, and short circuit protection. The PoE module requires a 100mA load at all times so the PoE Power Supply includes a 50 Ohm resistor to constantly load the module with 100mA. There's a cuttable jumper to remove this load if needed. At a 1A load we measured a low 20mVPP ripple at 200kHz. Note: The IT-CHRG-P2U provides power only - no network connectivity via the Apple charging port is permitted due to limitations in the iOS operating system.

PoE Texas PoE+ Power and Data Adapter for USB-C Tablets PoE Texas PoE+ Power and Data Adapter for USB-C Tablets

Have you tested this with POE switches from Cisco (802.3.at supported) to power Nest IQ Outdoor cameras?This GAT-USBC model will split output power and data. For power + data on the USB-C connection please see our GAT-USBC-PD and GAT-UBC-PD-REV2. Perfect for extending 5 volts of power to charge USB devices. Power your 5 volt USB and micro-USB devices from your existing PoE switch with this 5 volt Power over Ethernet splitter/converter. The GAF-USB Mode A/B inline step down splitter converts 44-56 volt PoE to 5 volts. The included female USB adapter is specially designed for Apple Fast Charge but may be used with any USB cable. The Microchip PoE to USB-C® adapter connects IoT devices with a USB-C connector to Power over Ethernet (PoE) networks, enabling users to leverage theadvantages of PoE and USB-C technologies. The PD-USB-DP60 is a PoE to USB-C adapter that provides both power and datato USB-C hosts and power to USB-C Powered

PoE to USB-C PD Power Adapter, 802.3 at Compliant Coolgear 22W PoE to USB-C PD Power Adapter, 802.3 at Compliant

A cleaner, cable-free office or classroom creates a productive workspace for end users and for IT administrators, PoE is a more streamlined, efficient alternative. For a PoE to USB-C solution with power + data, please see our GAT-USBC-PD or GAT- USBC-PD-REV2. The Rev2 is compatible with the iPad Pro Gen3, Microsoft Surface Go, Samsung Galaxy Tab Active, and Google Pixel phones. Our Rev1 will work with Microsoft Surface Go and Samsung Galaxy Tab Active. While both of these standards are still used (and sold) today, 802.3bt, or PoE++, can now deliver up to 51 watts DC (Type 3) or 71.4 watts DC (Type 4) to power a far wider range of devices using Cat 5 or better cabling. This standard also provides support for 10 gigabit wired networking.Running a small amount of power through your network cabling is surprisingly safe. Since PoE has been standardized, protections for the overloading and underpowering of devices have been built into standards since the early days of 802.3af. Our patent pending technology offers the powered range of PoE combined with the universality of USB Type C power and data communication